- High thermal conductivity: rapid and homogeneous radiation
- Increased contact area of the device with the environment, with a consequent increase in heat dissipation
- Environmentally friendly, water-based resin
- Electronics and Optoelectronics
- Lighting
- Paints and Varnishes
Appearance | Dark Grey Liquid |
Non-volatile content /% | ≥18 |
Viscosity /Pa.s | 800-1400 |
pH | 7-9.5 |
Range of Adhesion | 1.02-1.15 ≤1 |
Flexibility /mm | ≤2 |
Shock resistance/kg.cm | ≥40 |
Mix uniformly before applying. Application conditions: temp ≥10oC, humidity ≤ 85% Pre-treatment of the substrate is required. After this pre-treatment, the substrate must be clean of oil, rust or dust. It can be applied by brush, spray or decantation Drying at 25oC for 7 days (Relative Humidity: 50-80%RH); or 80oC for 24 hours. The DFT (Dry Film Thickness) should be ≥ 25μm