CONDUCTIVE GRAPHENE INK WATER BASED WITH BINDER

New

Product consists of graphene as a conductive element, binders and water. It is a very lubricating product and of high surface tension, excellent stability and with good adhesion to PET films.

More details

212,43 €

Add to wishlist

More info

Product consists of graphene as a conductive element, binders and water. It is a very lubricating product and of high surface tension, excellent stability and with good adhesion to PET films. It also offers ease of use in printable electronics, high conductivity, moderate drying condition, high resolution, low cost etc. This product plays a significant role in applications such as membrane switches, touchscreens and PCBs. It can also be mixed with silver inks to be used as printable RFID and in smart packaging.

  • Higher electronic conductivity compared to conventional carbon inks
  • Reduced cost compared to other conductive inks
  • High printing capacity and moderate drying condition
  • Packaging
  • Electronics and Optoelectronics
  • Construction
Solvent Water
Solid (wt%) 5~6
Sheet resistivity normalized to 1 mil (Ω/sq) As Deposited ~63
Sheet resistivity normalized to 1 mil (Ω/sq) After Pressing ~13
Density (g/ cm3 ) ~0.95
Drying (minutes) ~6 min @ 80°C
Viscosity (cps) 12.8
Coverage (cm2 /g/mil ) 64
Binder Yes

Before printing, shake vigorously for 5-10 minutes and let stand for 30 minutes. Dry at 130º for 30 min. Recommendations: Screen printing of 100-200 screens, printing on PET film, squeegee hardness of 70-80 degrees, with an angle of 50-70 degrees at a speed of 20-40 cm/s

3 other products in the same category: